How To Use AFI Camera Stabilizer &The work of Camera Stabilizer

Camera stabilizer is an effective tool for shooting smooth and stable lens. If your operator and camera have a shaking problem and no three tripod, the camera stabilizer will come in handy.

How to use the camera stabilizer correctly

But how do you use the camera stabilizer? The following information will explain how the camera stabilizer works.

Balance hinge

Connect the longest balance weight to the extended end of the balance balance. Once the camera is installed, you can add smaller balance weight if necessary. You don't need to tighten the unit too much, that's enough, so the screws do not move.

To get your starting place, first measure the distance from the hinge to the end of the mounting base by measuring the distance from the hinge. According to the weight of your camera, you need to adjust the hinge distance of the counter.

If your camera weighs a pound, you may need to adjust the distance by eight inches. If your camera weighs two pounds, the adjustment may be 12 inches. It depends on what kind of stabilizer you have.

If you need to modify the vertical balance, you can turn off or open the balance hinge by adjusting the vertical and horizontal screws. Remember that balancing weight has a direct effect on balance.

Installation camera

1. Remove the quick release camera plate from the receiver bracket.

2. Take the screws off the device.

3.. Hang the camera on the fast release device.

4. Tighten the screw.

5. Make sure that the receiver screws are safe wherever necessary. In most cases, screws must be tightened so that no playing is played.

If your DSLR camera has a heavy lens, you need to move the lens along the lens. If you install a camera, place the mounting plate slightly away from the center of the DSLR. You can also install the camera with any mounting screws.

Adjustment of vertical and horizontal decoration

1. Hold the handle with the camera on the platform. Hold it carefully and check whether the slope is left or right.

2. To adjust the side-by-side placement of the camera, loosen the bottom screws of the camera base. In most stabilizers, there is a screw for adjusting side-by-side screws. Once you have a balance, tighten the screw.

3. Test the balance of the camera. If the front is reversed, the direction of the front and back is adjusted.

4. If it is tilted, loosen the screws on the left or right side and make appropriate adjustments.

5. Tighten the screw after completion.